Gardenreet 100Pack Waterproof Electrical Wire Connector(AWG #22-10) for Outdoor Low Voltage Landscape Lighting

Features AWG COMPATIBILITY: Perfectly suited for wire sizes 22 AWG to 10 AWG wire and cable. WIDE RANGE OF USE: Black waterproof connectors are corrosion resistant and have a strong watertight seal for outdoor wire connectors exposed to steam, water, condensation or dust, such as For Low Voltage Landscape use, landscape lighting, irrigation valves, outdoor speakers wires, and low volt patio and deck lighting. HIGH QUALITY: Constructed of PVC, the internal silicone grease works from -40°C (-40°F) to 120°C (248°F), and they fit perfectly with the silicone filled cap to prevent any water or dirt from entering the connection. the grease cap outdoor electrical nuts caps are pre-filled with 100% silicone sealant, so you don't have to worry about falling off. EASY INSTALL: Black seal electrical connectors require no soldering, no electrical tape, and no tools to connect the wires; you simply connect the wires into the connector and rotate to complete the installation. REPLACEMENT WARRANTY: High quality and 5 year warranty, our customer support team always supports our products in any way, so please contact us for replacement if you have any quality problems. Product Description Gardenreet Waterproof Connectors are an innovative, patented product line that has effectively fueled the company's rapid growth. The unique screw-in connector is pre-filled with a silicone sealant that makes the connector waterproof and corrosion resistant. The products are easy to install and eliminate the need for time-consuming products such as heat shrink, tape, adhesives and corrosion kits. These products are available for outdoor/irrigation, outdoor/electrical, direct burial and low voltage use. Gardenreet Landscape waterproof wire connectors are ideal for: Outdoor low voltage landscape lighting Speaker wire Irrigation wire Landscape wire Rated up to 600V Product Description. Product Description: Fits AWG # 22-10 wire (10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22 AWG) Pre-filled with 100% silicone sealant to protect against moisture and corrosion 300pcs for easy storage Warranty - 5 years Installation Recommendations: Strip approximately 0.5 to 1 inch of copper from the wire. Turn clockwise while slowly pushing until the wire is very tight. Make sure there is no bare copper Expect a slight sealant during this process, it is very good. One time use only - not reusable Turn off power before working on the circuit (Keep this product out of the reach of children)